Configuring The Energy Saver Mode; Setting A Password - Ricoh MP C2800 Operating Instructions Manual

Configuring the Energy Saver Mode

Follow the procedure below to configure Energy Saver mode.
1. Start SmartDeviceMonitor for Admin.
2. On the [Group] menu, point to [Search Device], and then click [IPv4], [IPX/SPX] or [IPv4
SNMPv3].
A list of machines using the selected protocol appears.
Select the protocol of the machine whose configuration you want to change.
If you are using IPv4 SNMPv3, enter the user authentication.
3. Select the machine whose settings you want to make.
To make settings for all machines in the selected group, select no machine.
4. Click the [Group] menu, point to [Energy Save Mode], [Set Individually], and then click
[On].
To select all the machines in the group, select [Set By Group].
To disable Energy Save mode, click [Off].
5. Quit SmartDeviceMonitor for Admin.
• For details about the setting for Energy Saver mode, see SmartDeviceMonitor for Admin Help.

Setting a Password

Follow the procedure below to set a password.
1. Start SmartDeviceMonitor for Admin.
2. On the [Group] menu, point to [Search Device], and then click [IPv4], [IPX/SPX] or [IPv4
SNMPv3].
A list of machines using the selected protocol appears.
Using SmartDeviceMonitor for Admin
4
149