Replacing A Media Bay Blank - HP ProLiant ML30 Gen9 Maintenance And Service Manual

WARNING:
To reduce the risk of personal injury from hot surfaces, allow the drives and internal system components
to cool before touching them.
CAUTION:
To prevent improper cooling and thermal damage, do not operate the server unless all bays are
populated with either a component or a blank.
Procedure
1. Power down the server.
2. Disconnect the power cord from the power source and the server.
3. Remove the bezel.
4. Place the server on its side with the access panel facing up.
5. Remove the access panel.
6. Remove the air baffle.
7. Remove the M.2 SSD enablement board.
8. Remove SSD module.
To replace the component, reverse the removal procedure.

Replacing a media bay blank

Procedure
1. Power down the server.
2. Disconnect the power cord from the power source and the server.
3. Remove the bezel.
4. Remove the media bay blank.
42 Replacing a media bay blank