Button Clamp Zero Point - Pfaff 3371-10 SERIES Adjustment Manual

Adjustment
15

Button clamp zero point

.06
● Remove the button clamp holder and the lower feed plate .
● Screw adjustment gauge 1 (part no. 61-111 637-08) to the button clamp drive unit.
Preliminary adjustment
● Move the button clamp drive unit by hand in accordance with requirement 1.
● Adjust switch lug 2 (screw 3) and switch lug 4 (screw 5) in accordance with requirement 2.
Fine adjustment
● Switch on the machine.
● In the input mode, select parameter "608", see Chapter 11.03 Parameter input in the
3
Requirement
After the machine ahs been switched on and parameter "608" selected,
1. the needle should be centred to the hole in the adjustment gauge,
2. the switch lugs 2 and 4 should be centred to the respective initiator.
3
2
Fig. 15 - 02
instruction manual.
1
5
4