Error Messages On The Display - Pfaff 3371-10 SERIES Adjustment Manual

15

Error messages on the display

.34
Following error messages are shown on the control panel display.
ERROR: 1
ERROR: 2
ERROR: 3
ERROR: 4
ERROR: 5
ERROR: 6
ERROR: 7
ERROR: 8
ERROR: 10
ERROR: 11
ERROR: 12
ERROR: 13
ERROR: 14
ERROR: 30(#)
ERROR: 31(#)
ERROR: 50
ERROR: 51
ERROR: 52
ERROR: 101
ERROR: 102
ERROR: 103
ERROR: 201(#)
ERROR: 202
ERROR: 203
ERROR: 204
ERROR: 205
ERROR: 206
ERROR: 207
ERROR: 208
ERROR: 209
ERROR: 210
ERROR: 211
ERROR: 301
ERROR: 302
ERROR: 303
ERROR: 304
ERROR: 305
ERROR: 401
ERROR: 402
ERROR: 403
ERROR: 404
ERROR: 405
ERROR: 406
Processor error STACK_OVERFLOW
Processor error STACK_UNDERFLOW
Processor error UNDEF_OPCODE
Processor error PROTECTION_FAULT
Processor error ILLEGAL_WORD_OPERAND
Processor error ILLEGAL_INSTRUCTION
Processor error ILLEGAL_BUS_ACCESS
Processor error NMI
OTE (Sewing head recognition unit) not attached
OTE not programmed (new)
OTE check sum error
OTE header invalid
OTE user data invalid
(OTE error see cap. 15.36)
(Error Sewing motor see cap. 15.35)
Incorrect control panel
Incorrect machine class in OTE
Incorrect software for main drive
Mains voltage
Power supply overload
24 V too low
(Error Sewing motor see cap. 15.35)
Pattern too large
Overload data transfer sewing motor
Tacting function locked
Run function locked
No NIS
Not end of ramp
Zero point not found
Sewing function locked
Bobbin thread fault
Stitch too large
Raise clamp not completed
Lower clamp not completed
Raise clamp locked (needle position)
Lower clamp locked (needle position)
Thread wiper on locked (needle position)
Error sewing motor
Overload data transfer sewing motor
Program station not programmed
Program locked
Program does not exist
No NIS
Adjustment
40