Svga Display Option; Operating With A Discharged Vehicle Battery; Xga Display Option; Screen Calibration - Motorola MW 800 Owner's Manual

Hide thumbs Also See for MW 800:

Table of Contents

MW 800 Display Owner's Manual

SVGA Display Option

If during normal operation, the ambient temperature is higher than

the normal operating range the temperature LED will blink, the

display brightness level will be approximately one third of the

maximum level, and a warning message will be displayed on the

screen. When the LCD temperature sensor approaches +167°F

(+75°C), the MW 800 Display will automatically power off after 3

minutes.

If the ambient temperature drops to the normal operating range, the

display brightness will be automatically restored.

If, during normal operation, the vehicle battery voltage drops to

10.2V, the power status LED will blink and a warning message will

be displayed on the screen. If the voltage continues to drop, the

MW-800 will automatically power off at 8.5V.

During power cranking, the display backlight is automatically turned

off at 8V to save power. The backlight will be restored once the

vehicle battery voltage is a stable 10.4V for at least 4 seconds.

To calibrate the screen, do the following:

1. Press the OSD calibration button, located on the lower right hand

side of the display. The OSD application dialog box is displayed.

2. Use the calibration buttons and follow the instructions on the

screen.

Table of Contents