Table of Contents
Advertisement
vehicle security system. It has one short "bi" sound while
pressing the button of the LCD screen transceiver.
REMOTE START OPERATION:
A. TO REMOTE START THE VEHICLE:
When you want to start your vehicle,
Activate Remote
1. Press
button once on the transmitter.
Start
2. The parking light will activate to indicate the remote start received
the signal.
3. The engine will start in approximately 5 seconds.
4. Once the engine is running, after couple seconds the parking
lights will turn on and the climate controls will activate and adjust the
vehicle's interior temperature to your preset setting. (While the
vehicle is running, the "minutes" digit on the LCD screen will flash
and the will indicate count down timer based on the 5, 10, 20 or 30
minute run time set up by your installation center.)
5. The vehicle will run for a programmable 5 to 30 minute cycle
Engine Running
before shutting down. (When the unit shuts off the count down timer
will turn off and the transmitter will play a melody.)
NOT E: The Remote Start Unit will not start the vehicle if any one of the
following conditions exists:
1. The hood is opened.
2. The brake pedal is pressed.
3. The optional remote start enable toggle is switched to the "OFF"
position. (If installed)
4. The gear selector is in any gear other then "PARK" or
"NEUTRAL"
SAFE START (Child safety mode)
Factory default is set to press the
button once on the transmitter to start the
vehicle. You can program this feature to eliminate an accidental remote start:
1. The user presses the transmitter
buttons twice within 3 seconds to start the
vehicle. or
2. The user presses the transmitter
and
buttons at the same time to start the
vehicle.
NOTE: Contact your installing dealer to activate this feature.
B. OPERATE THE VEHICLE WHILE RUNNING FROM THE REMOTE
START:
To operate the vehicle while engine running from the remote start,
1. Insert the ignition key and turn it to "ON" (not the start) position.
2. Press the brake pedal.
19
Advertisement
Table of Contents
