Transmitter Operation; Active Arming - Lock & Arm - Auto Page RF-310 Operation Manual

TRANSMITTER OPERATION:

Transmitter Button
Button
– Button
Button
Button for 3 seconds
Button
– Button
Button
Button for 2 seconds
Button for 3 seconds
+ Button
Side button
ACTIVE ARMING – LOCK & ARM:
1. Press button on transmitter.
2. The siren will chirp once and parking light will flash once indicating that the system is now
armed. The vehicle doors will lock upon arming when interfaced with the security system.
Note: Defective sensor reminder: If the siren sounds 3 chirps, then you have left a door,
trunk, or hood lid ajar. (See Feature "I - 3 Programming)
SILENT ARMING / DISARMING: Press the
your security system with no chirp sound heard; arm / disarm confirmation will be through the
vehicles parking lights only.
SHOCK SENSOR / OPTIONAL SENSOR BY-PASS: Press the
twice within 3 seconds will arm the security system, by-pass the shock sensor or the optional
sensor connected to 4 pin plug. The system will chirp one additional time to confirm the
sensor bypass mode was activated. The sensor bypass feature is programmed to activate for
one arming cycle only. The security system will return to normal operation during the next
arming cycle.
PASSIVE ARM ING: (See Feature "II - 2" Programming)
Active arming / disarming is controlling your security system via the remote transmitter. This
security system is equipped with an optional Passive Arming feature, which allows the
security system to arm 30 seconds after the last door is closed. Operation is as follows.
1. Turn the ignition to the "OFF" position and exit the vehicle. (CONT. NEXT PAGE)
System Function
Arm / Lock door
Arm and Delete Optional Sensor
Car Locator
Panic function
Disarm & Unlock Door
Two Steps Door Unlock &
Disarm System
Car Locator
Pop Trunk Release
Panic function
Silent Arm / Disarm
Silent Arm / Disarm
2 nd Car Operation or
Garage Door Opener
button on the transmitter to arm or disarm
2
Remark
Press twice.
System in Armed.
Press 3 seconds
Press twice within 3
seconds.
Press 2 seconds
If the H3/6 Gray Wire is
not Trunk release Output
(See Alarm Feature III-2)
Side Button
Switching Code
button on the transmitter