Display Activation; Display Information - ABB AquaMaster 3 User Manual

AquaMaster 3
Electromagnetic flowmeter

4.2 Display Activation

To activate the display during normal operation:
1. Cover the display area for a few seconds.
2. Uncover the display area. The display is activated and the AquaMaster 3 cycles through the
programmed set of display measurements.
Note. To use local or remote serial communications, for instructions on how to alter the displayed set of
measurements and for meter setup, refer to COI/FET2XX–EN.

4.3 Display Information

Warning
Annunciators
Low Battery
Sensor Fault
Empty Pipe Condition
Mains Failure
Low GSM Radio Signal
Renewable Energy Not Present
Fig. 4.1 AquaMaster 3 Display Information
32
AB
1 2
4 Start-Up and Operation
Upper Display
Date
Forward Flow Total
Reverse Flow Total
ML
Net Flow Total
Tariff Total
kPa
Lower Display
Time
Flow Velocity
Pressure
User Guide OI/FET2XX–EN Rev. E