Identification Plates - SMART Fortwo 2015 Owner's Manual

Identification plates

216
Approved aerial positions
Front roof area
:
Rear roof area
;
Use Technical Specification ISO/TS 21609
(Road Vehicles – "EMC guidelines for fitting
aftermarket radio frequency transmitting
equipment") when retrofitting RF (radio fre-
quency) transmitters. Comply with the legal
requirements for add-on parts.
If your vehicle has fittings for two-way radio
equipment, use the power supply or aerial
connections intended for use with the basic
wiring. Be sure to observe the manufacturer's
additional instructions when installing.
Deviations with respect to wavebands, maxi-
mum transmission outputs or aerial positions
must be approved by smart.
The maximum transmission output (PEAK) at
the base of the aerial must not exceed the
following values:
Waveband
Tetra
380 - 410 MHz
Mobile communications
generation 2G/3G/4G
The following can be used in the vehicle with-
out restrictions:
RF transmitters with a maximum transmis-
R
sion output of up to 100 mW
Mobile phones (2G/3G/4G)
R
There are no restrictions when positioning
the aerial on the outside of the vehicle for the
following wavebands:
Tetra
R
Mobile communications (2G/3G/4G)
R
X
Example: vehicle identification plate
Maximum trans-
:
mission output
;
=
20 W
?
A
6 W
B
C
D
i
Identification plates
Vehicle identification plate with
vehicle identification number (VIN)
Open the front-passenger door.
You will see vehicle identification
plate :.
Vehicle identification plate
Paint code
Vehicle manufacturer
EU type approval number
Vehicle identification number (VIN)
Maximum permissible gross vehicle
weight
Maximum permissible front axle load
Maximum permissible rear axle load
The data shown on the vehicle identifi-
cation plate is example data. This data is
different for every vehicle and can deviate
from the data shown here. You can find the
data applicable to your vehicle on the
vehicle's identification plate.