Assembly Required - Haybuster 2650 Operating Instructions Manual

2.3 Assembly required

1. Adjust the tractor drawbar so that the distance from
the end of the P.T.O. shaft on the tractor to the
center of the drawbar hitch pin hole should be 16"
(41 cm.), and the height for the top of the centerline
of the P.T.O. should be 8" Refer to figure at right.
2. Hitch the 2650/2655 BALEBUSTER to the tractor
drawbar. Adjust the hitch so machine is parallel
with ground.
3. The hitch pin should be sized to prevent excessive movement, and should extend through all components
of the hitch. The pin should be secured with a hairpin clip or suitable device to prevent the loss of the pin.
4. Adjust the hitch so the machine will be parallel with the ground. Hitch the 2650/2655 BALEBUSTER to
the tractor drawbar.
5. Raise the jack, pull the lock pin and store in the transport position.
6. Connect the two hydraulic hoses from the hydraulic cylinder to one set of hydraulic couplers on the
tractor. Connect the two hydraulic hoses from the bale conveyor speed valve to the second set of
hydraulic couplers on the tractor.
7. Extend the loader hydraulic cylinder and hold the loader in the fully raised position. Remove the loader
transport pin and place them in the storage position, (the lowest hole in the bracket). Retract the loader
hydraulic cylinder completely, so the loader is in the lowest position.
NOTE: Always stand to the side of the loader when moving the transport pins.
8. Mount tines #8100033 and #8101075 and in the left mounting bracket, this is the standard position. For
small bales, use the inner brackets, and for the large bales use the outer brackets. Bolt in place using (2)
1x7 bolts #4800471 and lock nuts #4900127. See illustration on page 13.
9. Bolt Bearings Bracket #8101073 to mainframe with (4) ½ x 3-1/4 bolts #4800592, flat washer, spring
#6100031 & lock nuts. Compress spring to 2" length.
14 2 6 5 0 / 2 6 5 5 B A L E B U S T E R O P E R A T I N G I N S T R U C T I O N S