Towing/Road Transport - Haybuster 2650 Operating Instructions Manual

c. Watch out for and avoid any object that might interfere with the proper operation of the machine.
d. Replace missing or damaged flails.
• Power takeoff shafts must be locked in place with protective P.T.O. shields in place.
• Keep hands, feet and clothing away from power driven parts.
• Never leave tractor controls unattended while the engine is running.
• Never allow riders on the machine at any time.
• Be sure the tractor operator is the only person riding on the tractor.
• Exercise extreme care when operating on rough and/or steep terrain. Avoid operation on terrain which is
excessively rough or steep.
• Make sure your tractor P.T.O. speed never exceeds 1000 rpm.
Always stand to the side of the loader when moving transport pins. Never stand under the loader
•
unless the pins are installed in the upper holes on both sides. Never force pins out of position, when
the loader is fully raised pins can be moved easily.
DURING SERVICE & MAINTENANCE
• Before working on or near the 2650/2655 BALEBUSTER for any reason, including servicing, cleaning,
unplugging or inspecting machine, use normal shut-down procedures unless instructed differently in this
manual.
• Never work on or near 2650/2655 BALEBUSTER unless engine is shut off and flails stopped.
• Check periodically and tighten any loose bolts or connections.
• Use only replacement parts that are recommended by DuraTech Industries.
• If it is necessary to operate the tractor engine indoors for more than a few seconds, be sure to provide
enough ventilation to remove the tractor exhaust fumes.
• Hydraulic fluid escaping under pressure can be invisible and have enough force to penetrate the skin.
When searching for a suspected leak, use a piece of wood or cardboard rather than your hands. If injured,
seek medical attention immediately to prevent serious infection or reaction.
• Relieve all pressure in the hydraulic system before disconnecting the hose or performing other work on
the system. Make sure all connections are tight and the hose is in good condition before applying pressure
to the system.

1.6 Towing/road transport

• Use good judgment and drive slowly over rough or uneven terrain.
• Be sure tractor brakes are properly adjusted and foot pedals are locked together.
• When preparing implement for transport, always use loader transport pins to secure bale loader in raised
position. Do not remove transport pins until hydraulic hoses have been charged and cylinder is
fully extended. Never force pins out of position, when the loader is fully raised pins can be moved
easily.
• Check your state laws regarding the use of lights, slow moving vehicle signs, safety chain and other
possible requirements.
10 2 6 5 0 / 2 6 5 5 B A L E B U S T E R O P E R A T I N G I N S T R U C T I O N S