Setup Removing the Transport Covers Stacked Setup Configuration and Connecting Diagram System Requirements Terminal assignment NOMOS XLT combined with other K&F tops. Cardioid Arrays with NOMOS XLT 5.4.1 Setup instructions for a cardioid array 5.4.2 LSBlocks for cardioid use Cardioid Configurations with different Speakers...
Thank you for purchasing a KLING & FREITAG product. To guarantee a trouble-free operating of the equipment and to allow your KLING & FREITAG NOMOS XLT system to achieve its full potential read the user's manual carefully before use. This item is a quality accessory for the NOMOS XLT speaker system.
User's Manual K&F NOMOS XLT Safety Instructions For commercial use as specified in this document only! To prevent personal injury and damage, be sure to securely place or suspend the speaker as specified in the locally applicable standards. Warning The information described here does not relieve the user of the duty to follow the given safety requirements and legal regulations.
Make sure that the stacking feet of subwoofers stacked on top of one another are securely positioned in the grooves of the lower speaker. If you place a top speaker on a NOMOS XLT you must always strap the speakers to one another and secure them from falling over.
User's Manual K&F NOMOS XLT Setup Removing the Transport Covers To remove the transport lid, turn the appropriate catches 180° to completely release the latch. Lift the lid from the speaker. Stacked Setup Securely place the bottom subwoofer onto a level surface.
K&F NOMOS XLT NOMOS XLT combined with other K&F tops. The NOMOS XLT can only be combined in 2 channel mode with all K&F top speakers when using a K&F systemamp or systemrack. To do so, select the desired LS blocks for the top speaker in the K&F systemamp or systemrack, and combine these with the LS block for the NOMOS XLT subwoofer.
K&F NOMOS XLT Cardioid Arrays with NOMOS XLT The subwoofer NOMOS XLT is designed so that it can be used as a cardioid and hypercardioid system in an array of three subwoofers, or in multiples of three. A cardioid array results in an increase of sound pressure towards the front because of the rear-facing subwoofer.
The front-facing subwoofers are controlled via LSBlock for cardioid / hypercardioid arrays for front-emitting subwoofers. The following cardioid or hypercardioid setups are available in the CD 44: Operation Mode of the NOMOS XLT LSBlocks 'Cardioid Front', front-facing...
Fuse in the NOMOS XLT To increase the operating safety of the NOMOS XLT, the subwoofers are equipped with fuses at the signal input. These fuses reduce the risk of consequential damage resulting from a short circuit (i.e. charred cables / connectors / fire damage).
User's Manual K&F NOMOS XLT • 3 mm Allen key for loosening the front grille • 3 mm Allen key for loosening the chassis Instructions: Remove the front grille. Remove the speaker chassis. Pay attention to the correct polarity of the chassis.
User's Manual K&F NOMOS XLT 10. EC Declaration of Conformity applicable to all products designated hereafter and distributed by KLING & FREITAG GmbH including model variants unless these products have been altered afterwards. Loudspeaker systems: ACCESS B5 E 90 MK II...
13. Transportation and Storage The NOMOS XLT is protected against short-term moisture. despite, be sure to store, transport, and use the accessories in dry environments only. The NOMOS XLT System is not designed for long-term use in a corrosive environment.
User's Manual K&F NOMOS XLT All KLING & FREITAG products are plain business-to-business (B2B) products. Therefore, KLING & FREITAG GmbH is exclusively responsible for disposing of all KLING & FREITAG waste equipment marked with a garbage-can icon. Please call the below phone number when you have a KLING &...