Specifications; Standard Accessories - Hitachi M 12VE Handling Instructions Manual

English
g) Use the power tool, accessories and tool bits
etc. in accordance with these instructions,
taking into account the working conditions and
the work to be performed.
Use of the power tool for operations diff erent from
those intended could result in a hazardous situation.
5) Service
a) Have your power tool serviced by a qualifi ed
repair person using only identical replacement
parts.
This will ensure that the safety of the power tool is
maintained.
PRECAUTION
Keep children and infi rm persons away.
When not in use, tools should be stored out of reach
of children and infi rm persons.

SPECIFICATIONS

Model
Voltage (by areas)*
Power Input*
Collet Chuck Capacity
No-load speed
Main Body Stroke
Weight (without cord and

standard accessories)

* Be sure to check the nameplate on product as it is subject to change by areas.
STANDARD ACCESSORIES
(1) Parallel Guide ...............................................................1
(2) Template Guide ............................................................1
(3) Wrench .........................................................................1
(4) Wing Bolt (A) ...............................................................2
(5) Lock Spring .................................................................2
Be sure to check standard accessories on product as it is
subject to change by areas.
Standard accessories are subject to change without notice.
OPTIONAL ACCESORIES - sold separately
(1) Template Guide
A
16.5 mm
18.5 mm
25.5 mm
28.5 mm
8
8000 – 22000 min
Bottom of Sub
base
B C
18 mm
20 mm
4.5 mm
27 mm
30 mm
PRECAUTIONS ON USING ROUTER
1. Hold power tool by insulated gripping surfaces,
because the cutter may contact its own cord.
Cutting a "live" wire may make exposed metal parts of
the power tool "live" and shock the operator.
2. Use clamps or another practical way to secure and
support the workpiece to a stable platform.
Holding the work by your hand or against the body
leaves it unstable and may lead to loss of control.
3. Single-hand operation is unstable and dangerous.
Ensure that both handles are gripped fi rmly during
operation.
4. The bit is very hot immediately after operation. Avoid
bare hand contact with the bit for any reason.
M12VE
(110V, 120V, 220V, 230V, 240V)
2000 W
12 mm or 1/2"
–1
65 mm
5.3 kg
(2) Chuck Sleeve (8 × 6)
(3) Collet Chuck (8 mm)
(4) Collet Chuck (1/4")
(5) Dust collector set (Fig. 15)
(6) Fine adjustment knob (Fig. 15)
(7) Straight guide (Fig. 16)
Optional accessories are subject to change without notice.
APPLICATIONS
○ Woodworking
chamfering.
PRIOR TO OPERATION
1. Power source
Ensure that the power source to be utilized conforms
to the power requirements specifi ed on the product
nameplate.
2. Power switch
Ensure that the power switch is in the OFF position. If
the plug is connected to a receptacle while the power
switch is in the ON position, the power tool will start
operating immediately, which could cause a serious
accident.
M12SE
1700 W
22000 min
–1
20 mm
jobs centered on grooving and