Assembling And Adjustments; General; Handle; Cutting Height - McCulloch M46-110 CLASSIC Operator's Manual

General

IMPORTANT! Prevent unintentional
!
starting by removing the ignition cable
from the spark plug.

Handle

Assembly
Top handle
Place the handlebar's tubular construction in direct
opposite to the lower part of the handlebar. Tighten the
knobs properly.
Use enclosed straps to secure cables to the handle. Do
not overstretch cables when mounting.

Cutting height

NOTICE! Do not set the cutting height too low as there
is a risk that the cutters might hit ground with
unevenness.
Move the lever to the back for higher cutting height and to
the front for lower cutting height.
66 – English

ASSEMBLING AND ADJUSTMENTS

Catcher

Assembly of the catcher
• Place the frame into the fabric collector.
• The collector's handle situated on the frame must be
placed over the collector bag.
• Secure the frame by using the quick-action clips.
• Attach the hooks in the upper edge of the chassis. Fit
the bagger bottom in the discharge hole.

Mulch plug

Optional mulch kit accessory required to be ordered on
M46- models (kit PNC 579679201), M51- models (kit
PNC=579679301) and M53- models (kit
PNC=579679401). No kit available for M40 models.
• Raise the discharge guard to mount / dismount the
mulch plug.

Filling with oil

• The oil tank is empty at delivery. Fill the oil slowly. See
instructions under the heading Maintenance. The
engine oil should be changed according to the engine
manual.