Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for K-array KF212
Summary of Contents for K-array KF212
-
Page 1: User Guide
KF212 Ver. 1.0 KF212 USER GUIDE English... -
Page 2: Table Of Contents
KF212 Ver. 1.0 TABLE OF CONTENTS SYMBOLS ................3 1. INTRODUCTION ..............4 2. KEY FEATURES ..............4 3. pACKAgE CONTENTS .............. 4 4. SAFETY INFORMATION ............5 5. UNpACKINg ................. 6 6. phYSICAL OvERvIEw .............. 6 7. wIRINg ................7 ................ -
Page 3: Symbols
KF212 Ver. 1.0 SYMBOLS K-array declares that this device is in compliance with applicable CE standards and regulations. Before putting the device into operation, please observe the respective country-specific regulations! WEEE Please dispose of this product at the end of its operational lifetime by bringing it to your local collection point or recycling center for such equipment. -
Page 4: Introduction
Comprised of a 12” coaxial transducer with a titanium dome and a 12” passive radiator, the KF212 really packs a punch. With a depth of just 20 cm, the KF212 is the ideal solution for clubs and lounges up to live concerts. -
Page 5: Safety Information
KF212 Ver. 1.0 4. SAFETY INFORMATION Read these instructions - Keep these instructions - Heed all warnings Warning. Failure to follow these safety instructions could result in injury or damage to the device or other property. IMPORTANT SAFETY INSTRUCTIONS • Read these instructions. -
Page 6: Unpacking
Ver. 1.0 5. UNpACKINg Each K-array speaker is built to the highest standard and thoroughly inspected before leaving the factory. Upon arrival, carefully inspect the shipping carton, then examine and test your new amplifier. If you find any damage, immediately notify the shipping company. Only the consignee may institute a claim procedure regarding the system’s electronic equipment. -
Page 7: Wiring
7. wIRINg The KF212 features a 4-pin Phoenix connector similar to the other speakers, KF26 and KF210, in the Domino line. The KF212 only utilizes two pins to connect the speaker to the amplifier, as shown in the diagram below. -
Page 8: K-2Spk Accessory
Ver. 1.0 7.1 K-2SpK ACCESSORY This accessory is used to connect a Speakon cable to a KF212. It features two Speakon connectors wired in parallel providing the possibility to wire two units in parallel using Speakon cables. The two wires situated at the back of the K-2SPK carry the signal from the 1+ contact (red wire) and 1- contact (black wire) of the Speakon connector. -
Page 9: Setup
Ver. 1.0 8. SETUp 8.1 STACKED SETUp KF212 units can be positioned on a flat surface both in horizontal and in vertical position thanks to the four rubber feet included. KF212 in horizontal position on a flat surface KF212 in vertical position on a flat surface... -
Page 10: Hanging Setup
8.2 hANgINg SETUp The KF212 can be mounted on the wall using the four included wall brackets. 8.3 TILTINg ThE SYSTEM When a tilting angle is necessary, the KF212 can be mounted on the wall with the K-WALL2 accessory (not included). -
Page 11: Pole Mount
KF212 Ver. 1.0 8.4 pOLE MOUNT The KF212 can be mounted on a standard 35 mm diameter pole using the K-PMOUNT accessory (not included). -
Page 12: Service
9. SERvICE To obtain service: 1) Contact the official K-array distributor in your country. Your local distributor will direct you to the appropriate service center. 2) If you are calling for service, please have the serial number(s) of the unit(s) available for reference. -
Page 13: Technical Specifications
Present systems may differ in some respects from those presented in this catalogue. The contents of this manual are furnished for informational purposes only. K-array s.u.r.l. assumes no responsibility for any errors or inaccuracies that may appear in this manual. K-array s.u.r.l. reserves the right to make modifications without prior notice. -
Page 14: Certification
Paolina Romagnoli 17 50038 Scarperia e S. Piero Firenze ITALY Date of Issue: 14 / 03 / 2017 Model Code: KF210 – KF210W – KF212 – KF212W Declaration: Complies with safety essential requirements of Council Directive 2004/108/EC on the approximation of the Laws of the Member States relating to electromagnetic compatibility.