Download Print this page

Whirlpool 4KWED4750 Use And Care Manual page 12

Advertisement

Available languages

Available languages

TROUBLESHOOTING (cont.)
r
First try the solutions suggested here to possibly avoid the cost of a service call.
Cycle time too short
Automatic
cycle ending early.
The load may not be contacting
the sensor strips. Level the
dryer. See Installation Instructions.
Use Timed Dry for very small loads. Change the dryness level
setting on Automatic
Cycles.
Increasing or decreasing the dryness level will change the
amount of drying time in a cycle.
Lint screen clogged.
Dryer fabric softener was not
properly used.
Lint on load
Lint screen should be cleaned before each load.
Stains on load or drum
Add dryer fabric softener sheets at the beginning of the cycle.
Fabric softener sheets added to a partially dried load can stain
your garments.
Drum stains are caused by dyes in clothing (usually blue jeans).
These will not transfer to other clothing.
Loads are wrinkled
The load was not removed from
Select Wrinkle Shield option to tumble the load without heat
the dryer at the end of the cycle,
to avoid wrinkling.
Dryer tightly packed.
Dry smaller loads that can tumble freely help to keep wrinkles
from forming.
Odors
Painting, staining, or varnishing in
If so, ventilate the area. When the odors or fumes are gone
the area where your dryer is located,
from the area, rewash and dry the clothing.
Electric dryer being used for the
The new electric heating element may have an odor. The odor
first time.
will be gone after the first cycle.
Load is too hot
Laundry items removed from the
Allow the Cool Down status to finish before removing laundry
dryer before the end of the cycle,
from dryer. All cycles are cooled slowly to reduce wrinkling and
make it easier to handle. Items removed before Cool Down may
feel very warm.
L
High temperature cycle used, or
Select a lower temperature,
and use an automatic drying cycle.
TEMPERATURE/Fabric
control set
These cycles sense the temperature
or the moisture level in the
too high.
load and shut off when the load reaches the selected dryness.
_.
This reduces overdrying,
j
12

Advertisement

loading

This manual is also suitable for:

4kwed4900