Chicco URBAN PLUS Instructions For Use Manual page 21

To re-assemble the safety belts systems, follow the se-
quence below carefully:
19. Pass the belt through the slot as shown in Fig. 19, mak-
ing sure that the length adjuster is positioned as shown in
Fig. 19A.
20. Take the plastic slot end of the shoulder straps and intro-
duce it into the safety belt's fabric ring (Fig. 20).
21. After performing this operation properly, pull the belt
downwards until the fabric ring is turned inside out (Fig.
21A-21B).
22. WARNING: At the end of assembly, make sure that the
plastic slots are properly assembled. Check that the plastic
slots, once assembled on the relative safety harness buckle
forks, feature the relative horizontal protruding parts facing
the seat's exterior (fig. 22A-22B).
At the end of the assembly, the belts must be adjusted
once again according to the size of your child.
CONVERTING THE SEAT: PRAM CONFIGURATION
To transform the seat into a pram, follow the steps below:
23. Unfasten the buckles located under the seat (fig. 23 –
23A).
24. Position the foot rest horizontally, adjust the back rest
in the lowest position (Fig. 24), recline the seat by pressing
the buttons shown in Fig. 11, and bring the pram into the
horizontal position (fig. 24A).
25. Remove the safety belts (see paragraph REMOVE
SAFETY BELTS), making sure to store them away out of
the reach of your child.
WARNING: The pram must be used only in horizontal posi-
tion (fig. 25A). Do not adjust the pram when inclined (Fig
25B).
26. To introduce the fabric lining, fasten it to the fabric of
the stroller by using the internal zip (Fig. 26) located in the
child's head area.
27. Then wrap the elastic part of the fabric lining around the
tube of the structure in the foot area (Fig. 27). Lastly, fasten
the press stud buttons positioned on both sides (Fig. 27A).
WARNING: When the seat is in the pram configuration,
it should be fitted onto the stroller facing the parent (Fig.
27B-27C).
WARNING: In pram configuration, do not remove the seat
from the stroller when the child is inside it.
CONVERTING THE SEAT: SEMI-
RIGID CARRY COT CONFIGURA-
TION
IMPORTANT- KEEP THESE IN-
STRUCTION FOR FUTURE REFER-
ENCE.
WARNING: BEFORE USE, REMOVE
AND DISPOSE OF ALL PLASTIC BAGS
AND PACKAGING MATERIALS AND
KEEP THEM OUT OF REACH OF CHIL-
DREN.
WARNINGS
let before using the stroller.
WARNING: This product is only
suitable for a child who cannot sit
up unaided, roll over and cannot
push up on its hands and knees.
Maximum weight of the child: 9 Kg.
Indicative age of use:
months.
WARNING: Only use on a firm, hor-
izontal level and dry surface.
WARNING: Do not let other chil-
dren play unattended near the car-
rycot.
WARNING: Do not use if any part
of the carrycot is broken, torn or
missing.
approved by the manufacturer
sories, spare parts or components
not supplied or approved by the
manufacturer. Any unauthorised
modifications made to the product
will relieve the manufacturer from
all responsabilities.
fire and other source of strong heat,
such as electric bar fires, gas fires,
etc. in the near vicinity of carry cot.
physical and structural integrity. in
particular, the carrying handle and
the bottom of the carrycot. Should
any damage or signs of wear and
tear be noticeable, do not use the
product and keep out of reach of
children.
the correct position for use before
transport in the carrycot.
must never be kept lower than the
21
-
-