Additional Features; Information Mode; Unit Conversion Mode - Takagi 140 Indoor Installation Manual And Owner's Manual

You can get some information about the water heater condition by pressing the "INFO" button. For more
information, follow the procedures below:
INFO
BUTTON
Inlet water temperature will be displayed on the
1st. press
controller by pressing the "INFO" button.
Outlet water temperature will be displayed on the
2nd. press
controller by pressing the "INFO" button.
Water flow rate, in gpm, will be displayed on the
3rd. press
controller by pressing the "INFO" button.
4th. press
Press the "INFO" button to exit information mode.
Units of measure can be changed from Imperial to Metric and vice versa. For example, temperature can
be changed from °F to °C. Flow rate will also change from gallons per minute to liters per minute when
this setting is changed. Follow this procedure to change this setting:
Press the "ON/OFF" button on the controller in
1.
order to turn the controller on.
2.
When ON, the orange LED is lit.
The previous set temperature will be displayed on
3.
the screen.
4.
Press the "INFO" buttons for at least 3 seconds.
The set temperature should now be displayed in the
5.
alternate unit of measurement.
When the water heater is connected with the remote controller, the built-
NOTICE
in controller will not operate temperature settings. It will only work for the
information mode (Indoor model only).
ADDTIONAL FEATURES

-Information mode-

Operation

-Unit conversion mode-

Operation
43
Screen on the controller
Screen on the controller
Page
Owner's Guide
Normal Operation
Inlet water
temperature
(EX.: 60 °F)
Outlet water
temperature
(EX.: 120 °F)
Water flow
(EX.: 3.5 GPM)
(EX.: 100 °F)
(EX.: 38 °C)