Setting-Up System In Tech Mode - Samsung SF-830 Service Manual

Troubleshooting

4-4-2 Setting-up System in Tech Mode (

Title (Key)
SYSTEM DATA(Memu + One-touch01)
TECH MODE/USER MODE
SYSTEM ID(Memu + One-touch02)
DATE & TIME (Memu + One-touch03)
SYSTEM SETUP (Memu + One-touch04)
MEMORY CLEAR (Memu + One-touch05)
DELAY TX (Memu + One-touch06)
MEMORY TX (Memu + One-touch07)
PRIORITY TX (Memu + One-touch08)
POLLING (Memu + One-touch09)
ADD/CANCEL (Memu + One-touch10)
GROUP DIAL (Memu + One-touch11)
MAINTENANCE (Memu + One-touch12)
MAIL BOX (Memu + One-touch13)
CONFIDENTIAL TX (Memu + One-touch14)
DEPARTMENT CODE (Memu + One-touch15)
TX CONFIRM (Memu + One-touch16)
SCHEDULE JOB (Memu + One-touch17)
PHONE BOOK (Memu + One-touch18)
SYSTEM LIST (Memu + One-touch19)
TX JOURNAL (Memu + One-touch20)
RX JOURNAL (Memu + One-touch21)
HELP LIST (Memu + One-touch22)
4-6
SETUP : #, 1, 9, 3, 4)
Items
DIAL MODE
MODEM SPEED
ERROR RATE
SET TX LEVEL
SILENCE TIME
BATH TX
The same as User Mode.
The same as User Mode.
The same as User Mode.
CLEAR ALL MEMORY
The same as User Mode.
The same as User Mode.
The same as User Mode.
The same as User Mode.
The same as User Mode.
The same as User Mode.
ADJUST SHADING
CLEAN DRUM
NEW DRUM
NOTIFY TONER
SWITCH TEST
MODEM TEST
SRAM TEST
DRAM TEST
ROM TEST
PATTERN TEST
CLEAR COUNT
ANSWER ON CNG
FLASH UPGRADE
PROGRAM DIAL
1 : SET , 2 : PRINT
CODE = *****
The same as User Mode.
The same as User Mode.
The same as User Mode.
USER MODE
The same as User Mode.
The same as User Mode.
MSG. CONFIRM
SCHEDULE JOB
PHONE BOOK
SYSTEM DATA
TRANSMISSION
RECEPTION
HELP LIST
PROTOCOL
ERROR CODE
Sub-itmes
TONE / PULSE
5% /10%
09-15
12 / NU / OFF
ON / OFF
ON / OFF
FLASH / ENGINE
"1-7 , ALL"
PASSWORD
TOTAL PAGE COUNT
CRU PRINTS COUNT
ADF SCAN COUNT
USED DRUM COUNT
USED TONER COUNT
1-4
LOCAL
REMOTE :
USER PROGRAM , EMULATION ,BOOT
PROGRAM
1 : SET , 2 : PRINT
Samsung Electronics