Preparing To Print - Toshiba GA-1120 Quick Start Manual

Hide thumbs Also See for GA-1120:

5 Preparing to print

UNIX (TCP/IP) workstation

IPX (Novell) network

Other Network Requirements

• Standard TCP/IP connectivity (for example, Sun SPARCStation or Silicon Graphics

workstation with Solaris version 2.5 or later or SunOS version 4.1.x software)

• TCP/IP printing software that conforms to RFC1179 (Berkeley lpd protocol)

• Novell server

• Novell NetWare software version 3.x, 4.x or 5.x

• Support for Ethernet SNAP, Ethernet II, Ethernet 802.3, and Ethernet 802.2 frame types

Preparing to print

To set up your GA-1120, you must perform the following tasks:

• Connect the GA-1120 physically to a functioning network.

• Conﬁgure the network server.

• Set up the GA-1120 from the Control Panel.

• Prepare client workstations for printing.

A brief explanation of each task follows.

Connecting the GA-1120 to a functioning network

When you add the GA-1120 to a network, it is assumed that a network

OTE

administrator has already installed a network cabling system and has connected

workstations and servers. For examples of different networks, see the

Guide.

• Prepare a network node for the GA-1120.

• Route the cable to a location near the copier where the GA-1120 will be installed

and attach the cable to the network interface of the GA-1120.

For more information, see Chapter 1 of the

• Connect the GA-1120 to the copier and print a test page.

For detailed instructions, see the

Conﬁguration

Guide.

Conﬁguration

Guide.

Conﬁguration

Part number: 45028013

Table of Contents