Group Adjustment - Bosch DDU S2 Plus Manual

11 | Online Measurement
11.4
11.4.1
11.4.2
Notice
Notice
108 / 136

Group adjustment

Group adjustment is the simultaneous online calibration of several channels. This
is useful e.g. to set all wheel forces and damper positions to '0' when the vehicle
is positioned on a flat patch.
Configuration of group adjustment
Group adjustment consists of two components:
▪ An input channel which triggers the adjustment event
▪ A group of input channels linked to the group adjustment event
Setting up the group adjustment trigger channel
1. Click 'Measurement Sources' in the Toolbox.
2. Drag the 'Group Adjustment Channel' element from the Toolbox and drop it
on the DDU 8.
A 'Group Adjustment Channel Wizard' opens.
Double-click
"add group
adjustment"
If a low‐active signal is selected as an input channel, do not
forget to enable the pull‐up resistor for the pin. Otherwise the
group adjustment will be triggered periodically.
See chapter 'Configuring a generic linear sensor
concerning the pull‐up‐resistor.
3. Click 'Next' when done.
The second part of the 'Computed Sensitivity/Offset Wizard' opens.
Working with automatically created measurement sheets is ex‐
plained in chapter 'Setting up an online measurement
4. Click 'Finish' when done.
5. Enter channel name and description.
6. Click 'OK' when done.
DDU S2 PLUS Manual
[} 82]' for further information
[} 100]'.
Bosch Motorsport