English Description; Introduction; Warning; Installation - Studer AJ 350-24 User's And Installer's Manual

STUDER Innotec SA

ENGLISH DESCRIPTION

I
NTRODUCTION
The AJ series sine wave inverters have been
designed to meet industrial and domestic
needs. They meet the highest requirements in
terms of comfort, safety and reliability.
Any device designed for the public electrical
grid of 230 V 50 Hz can be connected to them
(up to the nominal power of the inverter).
The AJ series is the perfect source of voltage in
any place where the public grid is not
available.
This document is an essential part of the inverter
and must always be carried with it and be
available for anyone

installation.

Should you have any doubt or question, do not
hesitate to contact your specialist salesperson
who will give you the best advice.
W
ARNING
A deficient assembly could result in damage to
the device, cause function failures or potential
damage to the users.
The working device generates a high voltage
which might be lethal in case of contact. So,
any manipulation of the inverter must be
carried out with utmost care and meet the
local rules.
THE OWNER MUST NOT MANIPULATE ANY PIECE
INSIDE THE INVERTER.
Opening the inverter or using it incorrectly will
result in the immediate loss of the warranty.
The inverter AJ is to be used only with a lead
battery. As for the use of batteries, follow the
manufacturer's instructions.
No current or voltage generating device
(public grid, generator, ...) may be connected
to the output of the inverter because this could
result into its destruction.
working on the
V3.04
I
NSTALLATION
The AJ sine wave inverter is an electronic
device, for which some caution must be taken
when installing it:
Place where the inverter is to be installed:
Out of reach for
especially children.
In a dry place (max. 95% humidity), and in any
case with no condensation.
Not directly on top of the batteries.
No easily inflammable material should be
placed directly underneath or close to the AJ.
Ventilation must be free, and a space of 10 cm.
on each side is needed for good evacuation of
the internal heat.

Mounting the inverter

The inverter shall
nonflammable surface by screws (diameter
max. 4 mm for AJ 275-AJ 1300 or max. 8 mm for
AJ 2100 and 2400) using the four holes
provided. The fixing screws are not supplied
with the inverter. It may be fixed in any position.
unauthorized persons,
be mounted on
AJ
a
5