Ikco RUNNA LX Owner's Manual page 67

WIPER AND SCREEN WASHER
3
Wiper
Wiper and screen washer control is by
the lever on the right side of the steering
wheel and only when the switch is ON.
0- OFF
1- Intermittent ( The interval between two
movements of wipers depends on speed
of the vehicle)
2- Slow
3- Fast
Warning
Ensure the wiper blades are not frosted (otherwise the wiper engine gets hot)
Check the blades and replace them when needed (approx. once a year)
Wash the windscreen regularly. If before stopping the windshield wiper (0 mode) to turn off the motor, wiper blades return to zero position.
If you switch the ignition OFF (position 0) before switching the wipers, the wiper blades stop at any position.
When you ignite ON, take the wiper at position 0, then the blades return to the initial position.
Ensure the wiper blades are in position 0 (stop), when you open the engine compartment (risk of injury)
66
Single wiper
Push the lever downward and release it
to have single wiper.
If you keep the lever down, the wiper
functions continuously.
Windscreen washing
Soon after pulling the lever, spray of the
water gets started ,then the wipers will
start moving after 0.7 second . Spray
of water continues as long as you have
the lever pulled towards yourself. But
soon after releasing the lever , wipers
stop moving after 3 times of movements.
Then the fourth movement of the wiper
takes place after 3 seconds cessation to
complete cleaning of the glass.