AEG BP5304001M User Manual page 32

32 www.aeg.com
Problem
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
The core temperature sensor
does not operate.
It takes too long to cook the
dishes or they cook too
quickly.
Steam and condensation
settle on the food and in the
cavity of the oven.
The display shows "C2".
The display shows "C3".
Possible cause
The oven is deactivated.
The clock is not set.
The necessary settings are
not set.
The automatic switch-off is
activated.
The Child Lock is on.
The fuse is blown.
The lamp is defective.
The plug of the core tem-
perature sensor is not cor-
rectly installed into the sock-
et.
The temperature is too low
or too high.
You left the dish in the oven
for too long.
You want to start the Pyroly-
sis or Defrost function, but
you did not remove the core
temperature sensor plug
from the socket.
The cleaning function does
not operate. You did not
fully close the door, or the
door lock is defective.
Remedy
Activate the oven.
Set the clock.
Make sure that the settings
are correct.
Refer to "Automatic switch-
off".
Refer to "Using the Child
Lock".
Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali-
fied electrician.
Replace the lamp.
Put the plug of the core tem-
perature sensor as far as
possible into the socket.
Adjust the temperature if
necessary. Follow the advice
in the user manual.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.
Remove the core tempera-
ture sensor plug from the
socket.
Fully close the door.