Quitting Management Client - Sony HAW-EIBU Installation Manual

2
Select [Express (recommended)], and click [Next].
Note
This section describes the express procedure only.
Therefore, the IP addresses for the network cameras
must be configured using the same segment as LAN
connectors 1 and 2 of the unit. For details on
"Address range scanning" and "Manual" procedures,
refer to the NVMS Enterprise Edition Administrator
Manual.
3
Click [Next] in the subsequent screens.
4
Select the checkboxes of the devices to use for each
camera, and click [Next].
Notes
• The following device types exist. For details, refer
to the NVMS Enterprise Edition Administrator
Manual.
– Cameras
– Microphones
– Speakers
– Metadata
– Inputs
– Outputs
• The available devices and their number vary
depending on the specifications of the cameras.
5
Click for [Default camera group].
Note
Each device must belong to at least one group.
6
Click to add a new camera group, and click [OK].
7
Use the same procedure to add other groups other
than camera groups.
8
Click [Finish].

Quitting Management Client

Click at the top right of the Management Client
screen to close the screen.
28