Transmission Assembly - GE GTUP270EMWW Technical Service Manual

Transmission Assembly

To remove the transmission assembly:
1. Remove the spin basket. (See
2. Remove the outer tub. (See
3. Invert the tub assembly on a protected surface.
4. Remove the 3/8-in. hex-head bolts that hold the
transmission assembly to the bottom of the tub.
(16 bolts for 27-in model and 14 bolts for 24-in.
model.)
5. Transfer the motor and belt to the new
transmission assembly.
Important: A new tub seal is supplied with the new
transmission assembly. Press the new seal into the
bottom of the tub before installing the transmission.
Tub Seal
Important: After installing the transmission
assembly to the outer tub, transfer the fl at washer
to the transmission spin tube before installing the
spin basket.
.)
Spin Basket
.)
Outer Tub
– 53 –
Water Valve
Each water valve coil has an approximate resistance
value of 1.1K .
To remove the water valve:
Note: To replace the water inlet valve; the entire unit
must be removed from its location.
1. Remove the entire unit from its location.
2. Turn off the water supply to the appliance.
3. Remove the fi ll hoses from the water valve.
4. Remove the cover assembly. (See
.)
Assembly
Note: To increase access to the valve, it may be
helpful to remove the 2 damper rods at the front of
the outer tub and lean the tub forward.
5. Disconnect the wire harnesses from the valve.
6. Remove the outlet hose from the valve.
Disconnect
Disconnect
7. Remove the 1/4-in. hex-head screw that
attaches the water valve to the rear of the unit.
Cover
Outlet Hose