In the service position, 4 lock tabs located on the
bottom of the control panel will be engaged in 4
slots in the dryer front panel. The control panel can
be moved to the right to disengage it from the front
panel.
Note: The washer controls are installed on the
control panel. The dryer timer and start switch
remain on the dryer front panel.
Lock Tab (1 of 4)
Washer Controls
Washer Selector Controls
To replace any of the washer selector controls:
1. Remove the service panel. (See
2. Remove the 2 Phillips-head screws and the heat
shield from the cabinet.
Heat Shield
3. Pull the selector control knob straight out from
the control panel.
4. Place the control panel in the service position.
(See
.)
Control Panel
Slot (1 of 4)
Start Switch
Dryer Timer
.)
Service Panel
– 23 –
5. Lift the locking lever and rotate the selector
control counterclockwise.
Locking Lever
6. Remove both wire retainers and disconnect the
control wire harness from the control board.
Washer Buttons and LED Assembly
The washer buttons and LED assembly contains the
start/pause and fabric softener push buttons and
the LED status lights.
To replace the washer buttons and LED display:
1. Remove the service panel and heat shield. (See
and
Service Panel
Washer Selector Controls
2.)
2. Place the control panel in the service position.
(See
.)
Control Panel
3. Disconnect the wire harness attached to the
assembly.
4. Carefully release the 5 lock tabs and pull the
assembly from the control panel.
Disconnect
, step