Agitator - GE GTUP270EMWW Technical Service Manual

Agitator

To remove the agitator:
1. Pull the fabric softener dispenser from the top of
the agitator.
2. Using a 13- to 15-in. socket extension, remove
the 3/8-in. hex-head bolt inside the agitator.
Note: In the following step, to protect from back
injury, use agitator strap, part # WX5X1326 or
equivalent.
3. Position the agitator strap as shown, then lean
the washer tub forward and remove the agitator
by sharply pulling up on the strap.
Washer Components
WARNING: Sharp edges may be exposed when
servicing. Use caution to avoid injury. Wear Kevlar
gloves or equivalent protection.
Front Panel
The front panel is attached to the washer cabinet by
2 bottom hooks and 2 top lock tabs.
To remove the front panel:
1. Insert a putty knife between the washer top and
the front panel 4-1/8 inches from each side.
2. Press in on each lock tab and pull the top of the
front panel forward.
4-1/8 inches
3. Lift the front panel and remove it from the
bottom 2 hooks.
– 41 –