Advertisement
INSTALLATION NOTES
2. Insert TF card in the recorder slot. (Note: Please use a high-speed Micro SD
(Class 10 or above) with a capacity of not less than 2MB.
A 32GB card is supplied when the unit is purchased.
3. Connect the YELLOW power cable to 12V power supply, RED ACC ignition control,
BLACK earth. Insert the YELLOW RCA connector into the optional AV video or
navigation input circuit interface of your vehicle (if available). Start the engine. Check
that the unit is installed correctly with the red light blinking and the machine starting
video recording.
Machine Interface -
(pay attention to the direction of the slot)
INSTALLATION NOTES
ON/OFF/ENTER
In standby mode, hold down this button to shut down. Press momentarily for video
is successful. Press again to cancel the connection.
Yellow +12V Constant Power
Red ACC Ignition Control
Black GND Ground
Machine Adaptor Cable
4
Hide quick links:
Advertisement
