Squeegee System; Functional Overview; Electrical System Diagram; Form No. 56043052 / Hydro-Retriever™ 2052, Cr - Nilfisk-Advance HYDRO-RETRIEVER 2052 Service Manual

Hide thumbs Also See for HYDRO-RETRIEVER 2052:
Table of Contents

Advertisement

SQUEEGEE SYSTEM

SQUEEGEE LIFT MOTOR SYSTEM GENERAL OVERVIEW
The squeegee pick up tool is raised and lowered by an electric actuator motor and cable assembly located at the back of the machine, below the
battery and recovery tank. The squeegee lift circuit is controlled by the S6 vacuum/squeegee switch located on the dashboard, the reverse
directional switch S2 mounted on the drive pedal linkage and the E2 actuator controller mounted in the left panel electrical box are the system
components that manage the functions of the F5 squeegee lift motor.
Squeegee Lift Motor Function
See diagram below. To lower the squeegee tool to the floor place the S6 vacuum/squeegee rocker switch to the on position. With the S6 vacuum/
squeegee switch closed a negative 36V passes through the closed S2 reverse switch and is the direction-input signal for the E2 controller. The
negative 36V at the direction terminal energizes the internal relay built into the module and directs the correct output voltage (polarity) to run the
M5 squeegee lift motor. The lift actuator motor uses two internal limit switches to open the motor circuit and stop the motor's travel for both raising
and lowering functions. To raise the squeegee tool the drive pedal must be placed in reverse and this opens the S2 reverse switch and removes
the –36V input signal to the E2 module. Note: It can also be raised by placing the S6 switch in the middle (off) position, which also removes the
–36V signal to the module. The E2 direction terminal will now read zero volts and this de-energizes the internal relay and changes the polarity
at the module's output and the squeegee tool is raised automatically.
+
+
S6
GRN/BRN
BLU
F2
RED
Squeegee System Electrical Diagram
Note: Squeegee Tool Is Shown Lowered
50 - FORM NO. 56043052 / HYDRO-RETRIEVER™ 2052, CR 1300
BLU
WHT/GRN
S2
D7
K7
K7
WHT/YEL
RED/WHT
WHT/BLU
M5
M
M6
BLK
M
RED/BRN
YEL/BRN
S3
Forward Throttle Switch
revised 3/00
_
BLK
B+
E2
B-
GRA/WHT
Motor-
WHT/BRN
Motor+
Direction
ORN/WHT
Timer Out
WHT/RED
Timer In 1
Timer In 2

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents