Installing Child Restraints Using A Seat Belt - Toyota COROLLA iM 2017 Service Manual

Installing child restraints using a seat belt

Rear-facing ⎯ Infant seat/convertible seat
■
1
Place the child restraint sys-
tem on the rear seat facing
the rear of the vehicle.
2
Run the seat belt through the
child restraint system and
insert the plate into the
buckle. Make sure that the
belt is not twisted.
3
Fully extend the shoulder belt
and allow it to retract to put it
in lock mode. In lock mode,
the belt cannot be extended.
4
While
restraint system down into
the rear seat, allow the
shoulder belt to retract until
the child restraint system is
securely in place.
After the shoulder belt has
retracted to a point where there
is no slack in the belt, pull the
belt to check that it cannot be
extended.
COROLLA iM_U (OM12K64U)
pushing the child
1-1. For safe use
59
1