Changing Settings Of The Pre-Collision System; Enabling/Disabling The Pre-Collision System; Changing The Pre-Collision Warning Timing - Toyota COROLLA iM 2017 Service Manual

166
4-5. Using the driving support systems

Changing settings of the pre-collision system

■

Enabling/disabling the pre-collision system

Press the PCS switch for 3 sec-
onds or more.
The PCS warning light will turn
on and a message will be dis-
played in the multi-information
display, when the system is
turned off.
To enable the system, press the
PCS switch again.
The pre-collision
enabled each time the engine is
started.
■

Changing the pre-collision warning timing

Press the PCS switch to display the current warning timing in the
multi-information display. Each time the PCS switch is pressed in
the displayed state, the timing for the warning changes as follows:
If the operation timing setting has been changed, the setting will be
retained the next time the engine is started.
1
Far
The warning will begin to oper-
ate earlier than with the default
timing.
2
Middle
This is the default setting.
3
Near
The warning will begin to oper-
ate later than with the default
timing.
COROLLA iM_U (OM12K64U)
system is