Ice And Water Dispenser; Controls - GE ZIS360NR Technical Service Manual

The icemaker is mounted to the upper left wall of
the freezer cabinet. Under normal operating
conditions, temperatures, door openings, and food
load, the icemaker is capable of producing
approximately 100 to 130 cubes in a 24-hour
period.
To service the icemaker, refer to GE Publication
31-9063.

Controls

The electronic controls on the dispenser are
interactive. The control panel is equipped with a
proximity sensor that causes the panel to light up
as you approach the dispenser (approx. 2 inches).
Removal
1. Remove the bezel from the outside of the
freezer door.
Note: On stainless steel models, the front panel
must be removed. Remove screws from top,
bottom, and hinge side. Pull out on hinge side.
2. Remove the screw from the bottom of the
control panel. Lift up and pull the bottom of the
panel out. Disconnect the connectors, and
remove the control panel.
3. Remove 4 screws and the backing panel.
4. From the back side of the panel, remove the
water switch and the light socket.
5. Remove 3 screws and the duct door solenoid.
Light Socket

Ice and Water Dispenser

Water Switch
– 13 –
I = On
Power Switch
0 = Off
Green
Power Light
Feeler Arm
4 Screws
Duct Door
Solenoid
Icemaker
Screw