Ice And Water Dispenser - GE GSE23GGEBB Owner's Manual And Installation

About the ice and water dispenser.
Spill Shelf
14
To Use the Dispenser
Select CUBED ICE , CRUSHED ICE
or WATER .
Press the glass gently against the top of the
dispenser cradle.
The spill shelf is not self-draining. To reduce
water spotting, the shelf and its grille should be
cleaned regularly.
If no water is dispensed when the
refrigerator is first installed, there may be air
in the water line system. Press the dispenser
arm for at least two minutes to remove
trapped air from the water line and to fill the
water system. To flush out impurities in the
water line, throw away the first six glassfuls
of water.
CAUTION: Never put fingers or any other
objects into the ice crusher discharge
opening.
Locking the Dispenser
Press the LOCK pad for
3 seconds to lock the
dispenser and control
panel. To unlock, press and
hold the pad again for 3
seconds.
Important Facts About Your Dispenser
Do not add ice from trays or bags to the
storage drawer. It may not crush or dispense
well.
Avoid overfilling glass with ice and use of
narrow glasses. Backed-up ice can jam
the chute or cause the door in the chute to
freeze shut. If ice is blocking the chute, poke it
through with a wooden spoon.
Beverages and foods should not be quick-
chilled in the ice storage drawer. Cans,
bottles or food packages in the storage
drawer may cause the icemaker or auger to
jam.
To keep dispensed ice from missing the
glass, put the glass close to, but not touching,
the dispenser opening.
(on some models)
Some crushed ice may be dispensed
even though you selected CUBED ICE. This
happens occasionally when a few cubes
accidentally get directed to the crusher.
After crushed ice is dispensed, some water
may drip from the chute.
Sometimes a small mound of snow will form
on the door in the ice chute. This condition is
normal and usually occurs when you have
dispensed crushed ice repeatedly. The snow
will eventually evaporate.
Dispenser Light
This pad turns the night
light in the dispenser on and
off. The light also comes on
when the dispenser cradle is
pressed. For models with a
bulb, if the light burns out, it
should be replaced with a 6
watt 12V maximum bulb. For
LED models, contact Factory
Service.
Quick Ice
(on some models)
When you need ice in a
hurry, press this pad to speed
up ice production. This will
increase ice production for
the following 48 hours or until
you press the pad again.
Door Alarm
(on some
models)
To set the alarm, press this
pad until the indicator light
comes on. This alarm will
sound if either door is open
for more than 3 minutes.
The light goes out and the
beeping stops when you
close the door.