GE ZIS360NR Technical Service Manual page 48

6. Turn the lamp protector to access the bulb.
Note: Always follow bulb manufacturer's directions for
handling and replacing bulbs.
7. Remove the bulb by holding the base and pulling
straight out. Replace with a new bulb and replace the
lamp protector.
WARNING: Lamp protectors must be replaced, or the
heat from the bulb could damage the refrigerator.
8. Holding up the light housing, place each lamp
assembly in its holder. Feed the attached wires
through the slots and tuck the wires outside the side
of the light housing.
9. Insert the tabs on the back of the light housing in the
slots on the back wall. Raise the light housing into
position and secure with the four screws.
10. Replace the light shield and rotate the support tabs
back out to support the front of the shield.
11. Remove the filter bypass plug and replace with the
water filter cartridge. Reset the Sabbath switch to the
ON position.
Climate Control Drawer Type 2 Bulb Replacement
WARNING: Halogen lights generate intense heat. Be
certain power is off and lamps have sufficient time to
cool before attempting to replace.
1. Set the master light switch to the OFF position and
allow the lamps to cool.
2. To access the lamps, remove the second produce
pan.
3. The lamps at the back, which face up, can be lifted
out. To access the lamp that shines into the Climate
Control drawer, twist the holder until the arrow points
toward the back of the refrigerator, then lift up.
4. Turn the lamp protector to access the bulb.
Note: Always follow bulb manufacturer's directions for
handling and replacing bulbs.
5. Remove the bulb by holding the base and pulling
straight out. Replace with a new bulb and replace the
lamp protector.
WARNING: Lamp protectors must be replaced, or the
heat from the bulb could damage the refrigerator.
– 48 –
Lower lamp
assemblies