General Procedure; Required Tools And Materials - Siemens RUGGEDCOM RX1400 Installation Manual

Chapter 2
Installing the Device
• Section 2.4, "Installing the Device in Hazardous Locations"
• Section 2.5, "Mounting the Device"
• Section 2.6, "Connecting the Antennas"
• Section 2.7, "Installing the SIM Cards"
• Section 2.8, "Inserting/Removing the MicroSD Card"
• Section 2.9, "Connecting the Failsafe Alarm Relay"
• Section 2.10, "Connecting Power"
• Section 2.11, "Connecting to the Device"
• Section 2.12, "Configuring the Device"
Section 2.1

General Procedure

The general procedure for installing the device is as follows:
1. Review the relevant certification information for any regulatory requirements. For more information, refer to
Section 6.1, "Approvals".
2. Mount the device.
3. Connect an antenna or antennas.
4. For LTE antennas only, install SIM cards.
5. Connect the failsafe alarm relay.
6. Connect power to the device and ground the device to safety Earth.
7. Connect the device to the network.
8. Configure the device.
Section 2.2

Required Tools and Materials

The following tools and materials are required to install the RUGGEDCOM RX1400:
Tool/Material
WLAN, LTE and/or GPS antennas
Antenna N-connect and/or SMA cables
AC/DC power cord (16 AWG)
Lightning protector
Shielded coaxial cables
SIM card(s) provided by the network carrier
Flathead screwdriver for mounting the device to a DIN rail
Phillips screwdriver for mounting the device to a rack or panel
6
RUGGEDCOM RX1400
Installation Guide
Available For Purchase From Siemens
ü
ü
û
û
û
û
û
û
General Procedure
a