Table of Contents
Advertisement
comes to stop, and then deeply push the Spindle
Lock Button down to the hilt until comes to lock
the position.
2. Loosen the Disk Lock Bolt with the accessory
g
Hex. Socket Screw Key 6, and remove the
Grinding Wheel.
6. HOW TO OPERATE THE TOOL
Start and Stop
To start, release the lock lever and grasp the throttle
lever.
To stop, release the throttle lever.
r
T
t
d
Adjust Valve
WARNING
s
Be sure to keep hands clear of moving parts.
The desired number of rotation between maximum rpm
and minimum rpm is obtained by turning the groove of
valve clockwise or counterclockwise with screwdriver.
.
Maximum rotation
Position the groove of Adjust Valve horizontal to main
body.
Minimum rotation
Position the groove of Adjust Valve vertical to main
MLG-40_E.indd 6
Fig. 4
Fig. 5
body.
Fig. 6
7. STORAGE
CAUTION:
When tool is not used, store it out of reach of
children.
Avoid storing the tool in a location subject to high
humidity. If the tool is left as it is used, residual
moisture on the inside can cause rusting. Before
storing, and after operation, oil the tool at the air inlet
with machine oil ISO VG-10 and run it for a short time.
8. MAINTENANCE
Supply additional appropriate amount of Shell Alvania
Grease S#2 into the Gear Case with about once a
month interval.
1. Loosen the Screw 4x12 and remove the Exhaust
Cover, the Toothed Washer CW-4, the Spacer,
and the Exhaust Filter.
2. Inject grease with a grease gun into the Grease
Port next to the Exhaust Port.
The outside diameter of the nozzle tip of the
grease gun must be 4mm or smaller. The nozzle
for grease nipple cannot be used for this grease
filling, because the shape of the Grease Port is
different from that of the nozzle for grease nipple.
3. Before putting back the Exhaust Cover, execute
idle running and wipe out excessive grease.
4. For assembly, see Fig.7 and put back the parts in
the reverse order of disassembly.
Fig. 7
6
10.4.13 10:00:12 PM
Advertisement
Table of Contents
