2.8.6 MPT-HC V2
MPT-HC V2 is similar to MPT-HC from architecture standpoint and can be used as spare part of the MPT-
HC. The differences vs MPT-HC are:
–
MPT-HC V2 can be natively Ethernet powered through a proprietary PFoE
–
MPT-HC V2 is capable to host external modules (RPS module for 1+1 configurations or XPIC_RPS
module for XPIC and/or 1+1 configurations).
Two mechanical solutions are adopted:
[1]
with embedded diplexer for cost optimisation (6 GHz and 11 GHz to 38 GHz), shown in Figure 68.,
where the branching (diplexer) is internal to the MPT-HC V2 cabinet; this type of MPT-HC V2 is iden-
tified by one Logistical Item only;
[2]
with external diplexer: due to an high number of shifters the diplexer is external for the flexibility of
the shifter customization (7 GHz and 8 GHz), where MPT-HC V2 is composed by two independent
units: the BRANCHING assembly (containing the diplexer) and the RF TRANSCEIVER assembly
(containing the RF section); each of this type of MPT-HC V2 is identified by two Logistical Items,
one for the BRANCHING assembly and another for the RF TRANSCEIVER assembly. To read the
BRANCHING assembly identification label it is necessary to separate the BRANCHING assembly
from the RF TRANSCEIVER assembly.
Figure 68. MPT-HC V2 housing (6 GHz and 11 GHz to 38 GHz)
9500 MPR Rel. 3.1
150/980
3DB18809AAAA Issue 1
User Manual
Product information and planning