Setting The Clock; Setting The Alarm Time - Grundig Sonoclock 490 User Manual

SETTINGS

Setting the clock

When you switch on the device for
the first time, the time flashes in the
display to indicate that you must set
the clock. The same thing applies
after a power failure, or if the device
has been plugged out and no back-
up battery is inserted.
The time at Sonoclock 490 will be
synchronized by the mains frequen-
cy and for the Sonoclock 490Q it is
controlled by an integrated quartz
crystal.
1
Press and hold down »TIME«.
2 Press »UP« (hold down) to set
the clock with the time running
quickly forwards;
or
press »DOWN« (hold down) to
set the clock running slowly back-
wards
3
Release »TIME« to end setting.
Note:
Using »SNOOZE« (press and
7
hold down), display the sec-
onds (time e.g. »12:15« and 20
seconds, display: »5:20«).
18 ENGLISH
________________________________________

Setting the alarm time

1
Using »
set the desired alarm (» «= radio
station, » « = signal).
2 When the alarm is switched off
push the sliding switch
2« to »1« or »2«.
– Display: the
LED glows.
3 Press and hold down »ALARM«.
4
Using »DOWN« (hold down), set
the alarm time with the time run-
ning slowly backwards;
or
using »UP« (hold down), set the
alarm time with the time running
quickly forwards.
5 Release »ALARM« to end the set-
ting.
– The device switches on at the
set alarm times with the selected
alarm signal.
« sliding switch
»AL 1 1+2
1« or
»AL »AL
2«