Grundig Sonoclock 53 SC 5303 DCF User Manual

Grundig Sonoclock 53 SC 5303 DCF User Manual

Clock radio

Advertisement

Quick Links

CLOCK
RADIO
Sonoclock 53
SC 5303 DCF

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Sonoclock 53 SC 5303 DCF and is the answer not in the manual?

Questions and answers

Summary of Contents for Grundig Sonoclock 53 SC 5303 DCF

  • Page 1 CLOCK RADIO Sonoclock 53 SC 5303 DCF...
  • Page 2: Safety Information

    SAFETY, INFORMATION _____________________ ENGLISH Safety This device is designed for the playback of audio signals. Any other use is expressly prohibited. Protect the device from moisture (water drops or splashes). Do not place any vessels such as vases on the device. These may be knocked over and spill fluid on the electrical components, thus presenting a safety risk.
  • Page 3 OVERVIEW ___________________________________________ SONOCLOCK 53 SONOCLOCK 53 ALARM ALARM ALARM 108 MHz 108 MHz 108 MHz MW 530 MW 530 MW 530 1000 1000 1000 1300 1300 1300 1600 KHz 1600 KHz 1600 KHz Controls on the top SNOOZE Interrupts the alarm function. Stops the sleep timer. TIME Press and hold down to set the clock in combination <...
  • Page 4: Controls On The Back

    OVERVIEW ____________________________________ TUNING For tuning to radio stations (on the right side of the device). FM and MW frequency band switch, on the right side FM . . MW of the device. Controls on the back Ü Power cord. Wire antenna for FM reception. The device has a built-in antenna for MW reception.
  • Page 5: Power Supply

    POWER SUPPLY ___________________________________ Mains operation Note: Check that the mains voltage on the type plate (on the bottom of the device) corresponds to your local mains supply. If this is not the case, contact your specialist dealer. SONOCLOCK 53 SONOCLOCK 53 Plug the mains cable into the socket (230 V~, 50/60 Hz).
  • Page 6: Additional Information For Units Sold In The Uk

    “E”, earth symbol “ ”, coloured green, or green & yel- low. Replacement mains lead sets can be obtained from your local dealer, or by contacting Grundig Consumer Relations (01788 570088) Moulded 3-pin lead set, suitable for UK use: Ref: Leadset UK 8290-991-224...
  • Page 7: Automatic Settings

    SETTINGS ______________________________________________ Automatic settings Radio-controlled clock With you built-in radio-controlled clock, you are in possession of an absolutely precise alarm and appointments clock which is automatically set to the radio-transmitted time signals of the most precise clock in the world: the atomic clock of the Physikalisch-Technischen Bundesanstalt in Braun- schweig (PTB).
  • Page 8: Manual Settings

    ____________________________ SETTINGS Manual settings Setting the clock When the device is switched on for the first time and no time signal is recei- ved the clock starts with »00:00« in the display. The same applies after a power failure, or if the device has been unplugged and no back-up batte- ries have been inserted.
  • Page 9: Alarm Mode

    OPERATION __________________________________________ Switching on and off • »RADIO ALARM« to switch the device on and off. Radio operation For the best FM (VHF) reception, it is sufficient to direct the wire antenna accordingly. Tuning radio stations Select the desired frequency band with »FM .
  • Page 10: Timer Mode

    OPERATION _______________________________________________ Interrupting the alarm Press »SNOOZE« while the alarm is sounding. – The alarm (signal or radio) stops. – The alarm goes off again at 6-minute intervals (the total alarm time is 59 minutes). Cancelling the alarm for the day Press »ALARM«...
  • Page 11 Grundig AG Beuthener Str. 41 • D-90471 Nürnberg • http://www.grundig.com 3/09 72011 402 5500 •...

Table of Contents