Setting The Clock; Setting The Alarm Time - Grundig Sonoclock 390 Manual

SETTINGS

Setting the clock

When you switch on the device for the first time, the time flashes in the display
to indicate that you must set the clock. The same thing applies after a power
failure, or if the device has been plugged out and no back-up battery is
inserted.
Press and hold down »
1
Press »
2 HOUR
through the hours quickly.
Press »
3 MIN
through the minutes quickly.
Note:
When the minute display changes from »59« to »00«, this does not affect
the hour display.
Release »
4 TIME
– Display: the current time.

Setting the alarm time

Press and hold down »
1
Press »
2 HOUR
through the hours quickly.
Press »
3 MIN
through the minutes quickly.
Release »
4 ALARM
Use the »
5
= radio station » « = signal tone).
– Display: the » « LED lights up, i.e. the alarm setting is activated.
– The device switches on at the set alarm time with the selected alarm
signal.
18 ENGLISH
________________________________________
TIME
« briefly to set the hours step-by-step or hold it down to run
« briefly to set the minutes step-by-step or hold it down to run
« to conclude the setting.
ALARM
« briefly to set the hours step-by-step or hold it down to run
« briefly to set the minutes step-by-step or hold it down to run
« to conclude the setting.
« slide switch to set the alarm signal you require (» «
«.
«.