Guest Group Table - Cisco WAP125 Administrator's Manual

Access Control

Guest Group Table

On the device, each local user is assigned to a user group and the group is assigned to a CP instance. The
group facilitates managing the assignment of users to CP instances.
The user group named Default is built-in and cannot be deleted.
To configure a local user:
Step 1 Select Guest Access > Guest Group Table.
Step 2 In the Guest Groups Settings area, configure the following parameters:
• Guest Group Name — Specify the name for the new guest group. The default Guest Group Name is Default
Step 3 Configure these parameters:
• Idle Timeout — Enter the period of time that a user remains in the CP authenticated client list after the client
disassociates from the WAP device. If the time specified in this field expires before the client attempts to
re-authenticate, the client entry is removed from the authenticated client list. The range is from 0 to 1440 minutes.
The default value is 60. The timeout value configured here has precedence over the value configured for the CP
instance, unless the user value is set to 0. When it is set to 0, the timeout value configured for the CP instance is
used.
• Maximum Bandwidth Up — Enter the maximum upload speed, in megabits per second, that a client can transmit
traffic when using the Captive Portal. This setting limits the bandwidth used to send data into the network. The
range is from 0 to 866 Mbps. The default is 0.
• Maximum Bandwidth Down — Enter the maximum download speed, in megabits per second, that a client can
receive traffic when using the Captive Portal. This setting limits the bandwidth used to receive data from the
network. The range is from 0 to 866 Mbps. The default is 0.
• Total Guest Users — Displays the number of total guest users. Click the value link on the Total Guest Users to
display the Guest User Account page.
Step 4
Click Save.
Cisco WAP125 Wireless-AC/N Dual Band Desktop Access Point with PoE
Guest Group Table
83