Notification; Led Display; Log Settings - Cisco WAP125 Administrator's Manual

System Configuration
◦Starts — Select the week, day, month, and time when daylight savings time starts.
◦Ends — Select the week, day, month, and time when daylight savings time ends.
◦Daylight Saving Offset — Specify the number of minutes to move the clock forward when daylight savings
time begins and backward when it ends.
Step 5 Click Save. The changes are saved to the Startup Configuration.
Click Sync Time with PC, the system time of the device will be same as the
Note
PC.

Notification

This section details the process to enable and configure notifications for the access point.

LED Display

The WAP device has two type of LEDs: System LED and Ethernet LED. Use the LED Display page to
configure all LEDs.
To configure the LED Display do the following:
Step 1 Select Notification > LED Display.
Step 2 Select Enable to enable the LEDs. Select Disable to disable the LEDs. Select Associate Scheduler and go to Step 3.
Step 3
Select a profile name from the drop-down list for the Associate Scheduler LED Display. By default there is no profile
associated to the LEDs. The drop-down selection will show the configured Scheduler Profile Names configured in the
Wireless > Scheduler page.
When the LED is associated to a Scheduler Profile, this column shows the status depending on the presence or absence
of an active profile rule at that time of the day.
Step 4
Click Save.

Log Settings

Use the Log Settings page to enable log messages to be saved in permanent memory. You can also send logs
to a remote host.
If the system unexpectedly reboots, the log messages can be useful to diagnose the cause. However, log
messages are erased when the system reboots unless you enable persistent logging.
Cisco WAP125 Wireless-AC/N Dual Band Desktop Access Point with PoE
Notification
17