Snmpv3 Targets; Security; Radius Server - Cisco WAP125 Administrator's Manual

SNMPv3 Targets

Step 4
Click Save. The user is added to the SNMPv3 Users list and your changes are saved to the Startup Configuration.
To remove a user, select the user in the list and click Delete. To edit a user, select the user in the list and click
Note
Edit.
SNMPv3 Targets
The SNMPv3 targets send SNMP notifications using Inform messages to the SNMP manager. For SNMPv3
targets, only the Informs are sent, not traps. For SNMP versions 1 and 2, the traps are sent. Each target is
defined with a target IP address, UDP port, and SNMPv3 user name.
The SNMPv3 user configuration (see the
Note
the SNMPv3 targets.
The WAP device supports a maximum of eight targets.
To add SNMP targets follow these steps:
Step 1 Select Management> SNMPv3 Targets.
Step 2 Click ✚ to add a new row to the table.
Step 3 Check the check box in the new row and configure the following parameters:
• IP Address — Enter the IPv4 or IPv6 address of the remote SNMP manager to receive the target.
• UDP Port — Enter the UDP port to use for sending SNMPv3 targets.
• Users — Enter the name of the SNMP user to associate with the target. To configure SNMP users, see the
Users, on page 29
Step 4 Click Save. The user is added to the SNMPv3 Targets list and your changes are saved to the Startup Configuration.
To remove a SMMP target, select the user in the list and click Delete. To edit a SMMP target, select the user
Note
in the list and click Edit.

Security

This section describes how to configure the security settings on the WAP device.

RADIUS Server

Several features require communication with a RADIUS authentication server. For example, when you
configure the Virtual Access Points (VAPs) on the WAP device, you can configure security methods that
Cisco WAP125 Wireless-AC/N Dual Band Desktop Access Point with PoE
30
page.
SNMPv3 Users page) should be completed before configuring
System Configuration
SNMPv3