Wireless; Radio - Cisco WAP125 Administrator's Manual

Wireless

This chapter describes how to configure the wireless radio properties. It includes the following topics:
•
•
•
•
•

Radio

The radio is the physical part of the WAP that creates a wireless network. The radio settings on the WAP
control the behavior of the radio and determine what kind of wireless signals the WAP emits.
To configure the wireless radio settings:
Step 1 Select Wireless > Radio.
Step 2 Select the working mode:
• 2.4G Only — Support 2.4G Radio with a 2x2 MIMO mode.
• 5G Only — Support 5G Radio with a 2x2 MIMO mode.
• Dual Band — Support 2.4G and 5G Radio with two 1x1 SISO chains.
This is a single-silicon solution for operating the radio in either a 2x2 MIMO mode or as two 1x1 chains. This enables
the user to perform different tasks in two different bands or in the same bands (with some restrictions) simultaneously.
Step 3 In the Basic Settings area, configure these parameters for the selected radio interface:
Note Local regulations may prohibit the use of certain radio modes. Not all modes are available in all countries.
• Radio — Check Enable to enable the radio interface.
Radio, page 37
Networks, page 42
Client Filter, page 49
Scheduler, page 50
QoS, page 52
C H A P T E R
Cisco WAP125 Wireless-AC/N Dual Band Desktop Access Point with PoE
3
37