Routing And Connection Rca Interconnects / Remote Lead; Routing And Connection Of Loudspeaker Cables - RoDEK RN-1600 Installation Manual

4. ELECTRICAL WIRING
4.2 ROUTING AND CONNECTION OF RCA
INTERCONNECTS / REMOTE LEAD
Carefully run the RCA audio signal interconnect(s) and the
remote switching cable from the head unit to the amplifier. The
audio signal cables should be routed completely separate from
the power cables. Use only double or triple shielded quality
cables!
Connect the remote wire lead to the remote output of the head
unit and to the remote input terminal of the amplifier. Finally
connect the RCA interconnect cable(s) to the respective outputs
on the head unit and the RCA inputs of the amplifier.
4.3 ROUTING AND CONNECTION OF
LOUDSPEAKER CABLES
Connect the loudspeaker wires to the speaker terminals of the
amplifier. Use good quality wires of 2.5mm2 cross-section. You will
need a set of Allen wrenches for the connection of the wires!
When baring wires, remove approximately 6-8mm of the
insulation and after axially twisting the wires; insert the bare
ends into the corresponding speaker terminal output on the
amplifier. Be sure to follow correct polarity ("+" to "+"; "-" to
"-"). Tighten the terminal screws on the amplifier.
26