Model Rn-4110 - RoDEK RN-1600 Installation Manual

2. INPUTS – OUTPUTS – CONTROLS

2.3 MODEL RN-4110

1. RCA line outputs (CH L + CH R; left and right channels).
Line outputs to pass-thru the input signal to another amp
2. Input gain control. LEVEL adjustment for channels CH3
+ CH4. Used to match the RCA line output voltage of the
head unit to the amplifier input section
3. Bass EQ control. Bass emphasis adjustment for CH3 +
CH4 with a center frequency of 45 Hz from 0 dB to 10 dB
4. Lowpass crossover frequency control, to adjust the
cut-off frequency of the channels CH3 + CH4
5. X-Over operation mode slide switch. Used to select
high pass, band pass or full range operation of the active
crossover for channels CH3 + CH4
6. High pass crossover frequency control, to adjust the
subsonic cut-in frequency of the channels CH3 + CH4
7. Remote port. To connect the cable of the bass level
remote control to the amplifier, driving CH3 + CH4
8. RCA line inputs (CH3 + CH4; left and right channels).
Line inputs for connection of the amp with RCA line-outs
of the head unit
9. RCA line inputs (CH1 + CH2; left and right channels).
Line inputs for connection of the amp with RCA line-outs
of the head unit
10. Molded terminal for the connection of two speaker
wires for CH1 & CH2 and CH3 + CH4 to the amp
22
11. Maxi fuse to protect the power supply of the amplifier
from damage
12. "+12V" for connection to the positive terminal of car
battery
13. "REM" for the automatic (remote) turn-on / turn-off of
the power amplifier from the head unit's amplifier remote
wire
14. "GND" for connection to chassis ground or negative
terminal of car battery
15. Input gain control. LEVEL adjustment for channels CH1
+ CH2. Used to match the RCA line output voltage of the
head unit to the amplifier input section
16. Bass EQ control. Bass emphasis adjustment for CH1 +
CH2 with a center frequency of 45 Hz from 0 dB to 10 dB
17. Low pass crossover frequency control, to adjust the
cut-off frequency of the channels CH1 + CH2
18. X-Over operation mode slide switch. Used to select
high pass, band pass or full range operation of the active
crossover for channels CH1 + CH2
19. High pass crossover frequency control, to adjust the
subsonic cut-in frequency of the channels CH1 + CH2
20. RCA input operation mode slide switch. Used to
select 2CH input driving all four channels of the amp, or
4CH input to drive all four channels of the amp