Model Rn-460-200 - RoDEK RN-1600 Installation Manual

2. INPUTS – OUTPUTS – CONTROLS

2.4 MODEL RN-460-200

1. RCA line inputs (CH5; left and right channels). Line
inputs for connection of the amp with RCA line-outs of
the head unit
2. RCA line inputs (CH3 + CH4; left and right channels).
Line inputs for connection of the amp with RCA line-outs
of the head unit
3. RCA line inputs (CH1 + CH2; left and right channels).
Line inputs for connection of the amp with RCA line-outs
of the head unit
4. RCA input operation mode slide switch. Used to
select 2CH / 4CH or 5CH inputs, to drive all five channels
of the amp
5. Input gain control. LEVEL adjustment for channel CH5.
Used to match the RCA line output voltage of the head
unit to the amplifier input section
6. Bass EQ control. Bass emphasis adjustment for CH5
with a center frequency of 45 Hz from 0 dB to 10 dB
7. Low pass crossover frequency control, to adjust the
cut-off frequency of the channel CH5
8. Remote port. To connect the cable of the bass level
remote control to the amplifier, controlling CH5
9. Molded terminal for the connection of speaker wires
CH1 & CH2, CH3 + CH4 and CH5 to the amp
10. Maxi fuse to protect the power supply of the amplifier
from damage
11. "+12V" for connection to the positive terminal of car
battery
12. "REM" for the automatic (remote) turn-on / turn-off of
the power amplifier from the head unit's amplifier remote
wire
13. "GND" for connection to chassis ground or negative
terminal of car battery
14. Input gain control. LEVEL adjustment for channels CH3
+ CH4. Used to match the RCA line output voltage of the
head unit to the amplifier input section
15. Low pass crossover frequency control, to adjust the
cut-off frequency of the channels CH3 + CH4
16. X-Over operation mode slide switch. Used to select
high pass, low pass/band pass or full range operation of
the active crossover for channels CH3 + CH4
17. High pass crossover frequency control, to adjust the
subsonic cut-in frequency of the channels CH3 + CH4
18. Input gain control. LEVEL adjustment for channels CH1
+ CH2. Used to match the RCA line output voltage of the
head unit to the amplifier input section
19. High pass crossover frequency control, to adjust the
subsonic cut-in frequency of the channels CH1 + CH2
20. X-Over operation mode slide switch. Used to select
high pass or full range operation of the active crossover
for channels CH1 + CH2
23