Model Rn-1600 - RoDEK RN-1600 Installation Manual

2. INPUTS – OUTPUTS – CONTROLS

2.1 MODEL RN-1600

1. RCA line outputs (CH L + CH R; left and right channels).
Line outputs to pass-thru the input signal to another amp
2. RCA line inputs (CH L + CH R; left and right channels).
Line inputs for connection of the amp to the RCA line-
outs of the head unit
3. Input gain control. LEVEL adjustment for channels CH
L + CH R. Used to match the RCA line output voltage of
the head unit to the amplifier input section
4. Bass EQ control. Bass emphasis adjustment with a
center frequency of 45 Hz from 0 dB to 10 dB
5. Subsonic high pass crossover frequency control, to
adjust the subsonic cut-in frequency of the channels CH
R + CH L
Low pass crossover frequency control, to adjust the
6.
cut-off frequency of the channels CH L + CH R
7. Remote port. To connect the cable of the bass level
remote control to the amplifier
8. Molded terminal for the connection of two subwoofers –
"+" and "-" are connected in parallel, allowing to connect
two speaker wires whenever two subs are present
9. Maxi fuse to protect the power supply of the amplifier
from damage
20
10. "+12V" for connection to the positive terminal of car
battery
11. "REM" for the automatic (remote) turn-on / turn-off of
the power amplifier from the head unit's amplifier remote
wire
12. "GND" for connection to chassis ground or negative
terminal of car battery