Advertisement
STOP SCREEN
Pushing the <STOP/HOLD> button from the LCL_RUN screen will freeze the time, hold all operating
parameters at their current values, and display STP in the Mode Field.
Active Setpoint (S1 or S2) or Dev Limit (L1 or L2) alrams will display in the ALM field.
Push <RUN> to resume operation.
Push <PAGE DOWN> to access the Main Menu.
MAIN MENU Selection Menus
The menu of the 620A controller has 6 major selection screens. In the next sections each of these major menu screens
will be explained in detail. The major selection screens are broken down as follows:
1. SELECT PROGRAM TO RUN Screen
2. CHANGE CURRENT VALUE Screen
3. EDIT PROGRAMS Screen
4. CONFIG-TUNE CALIBRATE
4-1 CONFIGURE PROGRAMMER
4-2 CONFIGURE CONTROLLERS
4-3 CALIBRATE INPUTS
4-4 CALIBRATE OUTPUTS
5. MANUAL MODE
Manual % OUTPUT
6. DELAY_START
6
Advertisement
